How to use the pre-filled pen

Six steps, in pictures. The dial, its window, the units of your pen: it is all here.

Always in units AND in mg, for the pen in your hand.

The six steps

  1. Painting: the pre-filled pen in its box, next to 4 sealed pen needles.

    What is in the box

    One pre-filled pen (5, 10 or 20 mg): a 3 mL cartridge, ready-made solution. And 4 pen needles, each under its own seal. No water or syringe needed.

  2. Painting: one hand holds the uncapped pen, the other screws a new needle, still in its outer cap, onto the tip.

    Screw on a new needle

    Pull off the white pen cap. Peel the seal off a needle, then screw it straight onto the tip until it stops. Then remove its two caps: the outer one, then the inner one. A new needle every time, never left on between two uses.

  3. Painting: the pen held upright, needle pointing up, a drop at the tip of the needle.

    Prime the new pen

    Once per pen, before its first injection. Turn the dial to 2 units = 0.033 mg (5 mg pen), 0.067 mg (10 mg pen), 0.133 mg (20 mg pen). Hold the pen with the needle pointing up and press the button until you see a drop at the needle tip. No drop: do it again. Without priming, air stays inside and the first dose is incomplete.

  4. Painting: close-up of the white dial turned by two fingers, and of the window showing the number of units next to the red pointer.

    Set the dose with the dial

    Turn the dial: the number of units shows in the window, next to the red pointer. It goes from 0 to 60 units, one unit at a time. The window counts units, not mg: for the same number, the mg change with the pen. Always read the table for the pen in your hand.

    Example shown: 15 units. 5 mg pen : 15 units = 0.25 mg · 10 mg pen : 15 units = 0.5 mg · 20 mg pen : 15 units = 1 mg.

  5. Painting: the pen inserted at a right angle into a pinched fold of belly skin, thumb pressing the button.

    Inject

    Take the pen out of the fridge 10 minutes before. Pinch a fold of skin on the belly and insert the needle at a right angle. Press the button all the way down, then count to 10 before pulling the needle out: pulled out too early, part of the dose stays in the pen. Unscrew the needle, put the cap back on.

  6. Painting: the capped pen lying on a fridge shelf.

    Keep it in the fridge

    Between +2 and +8 °C, away from light. Never in the freezer. Sealed, it keeps for 12 months. Once started, ideally use it within 4 weeks: a guide, not an expiry date.

The steps on video

Priming (2 units), setting the dial, injection. No sound.

Dial units and mg, pen by pen

Every pen holds its dose in 3 mL, that is 300 units: one unit is not worth the same from one pen to another. Use the table for yours.

5 mg pen1 unit = 0.017 mg · 60 units (the most per press) = 1 mg
DoseSet the dial to
0.25 mg15 units
0.5 mg30 units
1 mg60 units
10 mg pen1 unit = 0.033 mg · 60 units (the most per press) = 2 mg
DoseSet the dial to
0.25 mg7 to 8 units7 units = 0.233 mg · 8 units = 0.267 mg
0.5 mg15 units
1 mg30 units
2 mg60 units
20 mg pen1 unit = 0.067 mg · 60 units (the most per press) = 4 mg
DoseSet the dial to
0.25 mg4 units4 units = 0.267 mg
0.5 mg7 to 8 units7 units = 0.467 mg · 8 units = 0.533 mg
1 mg15 units
2 mg30 units
2.5 mg37 to 38 units37 units = 2.467 mg · 38 units = 2.533 mg

"7 to 8 units": the dose falls between two clicks, the dial has no half unit. Above 60 units, the dose takes several presses. Conversion only: this table recommends no dose.

Your pen, ready to use. Stock in France.